Machinery factory equipment factory recommends using 0cr20Ni80 nickel-chromium wire

Makkinarju fabbrika tagħmir fabbrika jirrakkomanda użu 0cr20Ni80 nikil-kromju wajer

Jekk ix-xerrej ix-xerrej is a manifattur of mechanical equipment factories, packaging machines, sealing machines, packaging machines, etc., li do not require temperature, about {{{0} degrees Celsius, it is recommended to use 0cr20Ni80 nickel-chromium wire. The nickel-chromium wire has good weldability. It is soft and not easy to be brittle, and it is better to use flat belt, għax the load power per square meter of flat belt is is larger than round wire, the width is higher, and the loss rate is smaller than round wire.

Elettriku tisħin tubu nikil-kromju elettriku tisħin liga tisħin tisħin wajer

1. High high temperature strength; 2. Good plasticity after long-term use; 3. High emissivity; 4. Non-magnetic; 5. Good corrosion resistance.

Hawnhekk is a tfakkira li meta klijenti jagħżlu a prodott, the cheaper it is, the better, and the more expensive is, the more appropriate is, the more suitable it is. When choosing a product, you need to analyze its cost-effectiveness, the price is right, and the quality is the best.

Kuljum manutenzjoni u spezzjoni ta ' vakwu sħana agħfas

1. The sealing ring of the steam elbow. Many vacuum heat press steam pipe rotating joints adopt asbestos packing sealing device. The asbestos thread is impregnated with polytetrafluoroethylene plastic and pressed tightly in the original stuffing box to avoid asbestos under high temperature. The stuffing is easy to system. The stuffing is easy to harden and the steam leakage occurs, the effect is better, but is is not konvenjenti to use. Meta sostituzzjoni l-issiġillar ring, the ring the ring behind the ball needs to be cut off at an oblique angle of 45 degree to be put on, but it ma ma jaffettwax l-issiġillar effett.

2. Maintenance of the hot plate of the vacuum hot press. The upper and lower liners of the hot press board have the function of protecting the surface of the hot press board. The upper liner directly affects the surface quality of the fiberboard. It is often easy to trap fibers and other dirt between the liner and the hot press board. The lining should be removed regularly. Board, clean up the dirt. The upper liner is generally changed once a week to polish the surface and ensure the quality of the finished surface.

3. When installing the upper liner, the fiberboard must be padded before it can be pressed up. Damaged or different sizes of slabs cannot enter the vacuum hot press, and it is not allowed to directly press the fiberboard without the liner. If the vacuum heat press is shut down for a long time, it is necessary to promptly remove the steam condensate in the heat press plate to avoid internal corrosion.

4. Parti (jew kollha) ta il hot plate of the vacuum hot press is not hot, li jindika li il-passaġġ huwa imblukkat jew il-passaġġ huwa "short-circuited". At this time, a special deep hole hole drilling rig is required to open the channel for inspection and remove the obstacles before continue to use it.

5. If the hot plate of the vacuum hot press is found to leak locally, it can be repaired and smoothed by electric welding. After welding, the water pressure should be tested, and the pressure should be 1.2---1.4 times the steam pressure. If the leakage is caused by severe internal corrosion, it should be replaced.

www.superbheater.com